Chapter II The basic characteristics and various properties of the husking rubber roller.
Release time:
2019-12-10
1. Classification, structure and type of rubber roller:At present, there are three categories of husking rubber rollers in China and the world, also known as the three series, named: wheeled, set-type, and ride-type.
Wheeled:Locate with the center flange 7L, and fix 3 or 4 bolt holes on the two main shafts of the husker.
Set:Locate with 46. conical surfaces at both ends, fix the pin groove in the conical surfaces at both ends on the two main shafts of the husker, and fix it with conical cap.
Pitch:Locate with the inner holes of the two ends of the lapes, and fix them on the two main shafts of the husker with the jacking screws on the two ends of the lapes.
Model and specification comparison table of husking rubber roller
2. The color of the outer layer of the rubber roller is:Brown, white, yellow three.
The outer rubber hardness of the rubber roller (Shore A) is 90 ° and 95 °.
3. Basic performance of husking rubber roller:
The basic performance of the husking rubber roller (the amount of grain grinding) depends on the physical and mechanical properties of the external rubber material, which is introduced as follows:
Hot News
Contact Us
+86 715-5260630
Address: No. 136-1, Development Avenue, Chibi Economic Development Zone
Fax: 0715-5261079
Contact Information
Address: No. 136-1, Development Avenue, Chibi Economic Development Zone
Mobile Website